![]() I changed the S value to 1 on the M569 P0.4 line in order to get the filament extruded but I must admit that I was surprised I had to do this, as it was working fine with the previous motor, so maybe that the hemera motor is setup to turn in the other direction, this is the only thing I can think of right now. Nominal steps per mm (x16): 397 Recommended current: 1.4A Peak (0.99 RMS) Filament diameter: 1.75mm Mass (Direct): 290 grams (Including V6 hotside) Direct Drive Dimensions. M906 X800 Y800 Z800 E800 I30 set motor currents (mA) and motor idle factor in per cent If youre using the standard Titan motor, start with: 837 Steps-per-mm. M203 X6000.00 Y6000.00 Z1200.00 E3600.00 set maximum speeds (mm/min) Firmware modification is not an optional step, in order for your Hemera unit to. M350 X16 Y16 Z16 E16 I1 configure microstepping with interpolation M569 P0.4 S1 physical drive 0.4 goes backwards I was just wondering if anyone else using an E3D hemera got their retraction. M569 P0.2 S0 physical drive 0.2 goes backwards M569 P0.1 S0 physical drive 0.1 goes backwards M569 P0.0 S0 physical drive 0.0 goes backwards We can also get the current steps per unit with the M503 command. If you don’t, they will be reset to the previous values when the printer shuts down. Send the M500 command if you want to save these settings to EEPROM. I believe the changes on config.g to be correct but I'm clearly missing something or my Hemera is faulty: For example, sending G92 X100 Y100 will set both the X and Y axes to 100 steps/mm. ![]() Ender 3 V2 Firmware Update (Marlin): 6 Simple Steps All3DP. When sending a G1 E100 F3000 command in the console I just get about 4,5mm extruded. 1: Author: 5 mm thicker and the Hemera mount holes are a bit wider. In this case, the biqu h2 extruder needs 932 steps/mm which translates to a. I'm having an issue on my Ender 5 Plus when trying to calibrate the extrusion following the replacement of a Microswiss hotend with a Hemera, I'm using a Duet 3 board the normal one not the mini. The print speed can be visualized per feature in the Layer view Feedrate. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |